EPSON Stylus Pro 7000

Revision B

4.2.3.7 Removing the CR Encoder Sensor

1.Remove the cutter housing as described in “Removing the Cutter Housing” on page 133.

2.Remove one screw (CPP M3x8) securing the CR Encoder Sensor, ground, and washer (M3). Then remove the CR Encode Sensor.

CR Encoder

Sensor

One screw

Figure 4-47. CR Encoder Sensor Removal

4.2.3.8 Removing the P_Edge Sensor

1.Remove the cutter housing as described in “Removing the Cutter Housing” on page 133.

2.Remove one screw (CBP M3x6) securing the P_Edge sensor and remove the sensor.

One screw

P_Edge sensor

Inner Face

Outer Face

Figure 4-48. P_Edge Sensor Removal

Disassembly & Assembly

Disassembly Flow

136

Page 136
Image 136
Epson 7000 service manual Removing the CR Encoder Sensor, Removing the PEdge Sensor, CR Encoder Sensor One screw