Epson 7000 service manual Sensors, Sensor Menu Options

EPSON Stylus Pro 7000 Revision B

SENSORS

This function allows you to confirm whether the sensors are operating properly. The current status (ON or OFF) of the sensors (one at a time) is shown in the LCD display, and you need to check the sensor operation by hand. For example, to check the Paper Set Lever position sensor, move the lever up and down.

Some, but not all, explanations:

† EdgeAD

Displays the status of the P_EDGE sensor.

† FrontAD

Displays the status of the P_FRONT sensor.

† RearAD

Displays the status of the P_REAR sensor.

† Ink lever B

Displays the status of the black-side (K/C/M) ink holder lever.

† Ink lever C

Displays the status of the color-side (Lc/Lm/Y) ink holder lever.

† Ink ID

The Ink ID sensor is a 3-bit sensor, and the ID number appears as 0~7.

Sensor on = 1 and sensor off = 0.

† X Ink NOT yy

Describes which cartridge is not installed if a missing cartridge is

detected.

[Pause] returns you to previous menu

[SelecType]

Sen: CR Origin xxx

Sen: PF Origin xxx

Sen: Cover xxx

Sen: Lever xxx

Sen: EdgeAD ttt vvv

Sen: FrontAD ttt vvv

Sen: RearAD ttt vvv

Sen: Paper Wide

Sen: HeadSlide xxx

Sen: Temp B 20° C

Sen: Temp C 20° C

Sen: Lever B Down

Sen: Lever C	Up
Sen: B Ink ID	7
Sen: C Ink ID	7
Sen: M Ink ID	7
Sen: Lc Ink ID	7
Sen: Lm Ink ID	7
Sen: Y Ink ID	7
Sen: B Ink NOT	B
Sen: C Ink NOT	Lm
Sen: B Ink END	B
Sen: C Ink END	Lm
[Item]

X = "B" or "C" head and yy = ink color such as Lc.

† X Ink END yy

Describes which cartridge is empty if an empty cartridge is detected.

X = "B" or "C" head and yy = ink color such as Lc.

Figure 5-6. Sensor Menu Options

C H E You need to perform the “Sensor Adjustment” as described on

PO I the next page after replacing the Main board as well as any of the P_THICK, P_REAR, and P_FRONT sensors.

Adjustment Self-Diagnostic Mode Menus 168