Epson 7000 service manual General Errors, Ink Low, Paper OUT

EPSON Stylus Pro 7000 Revision B

3.4 General Errors

This section describes error that can be solved by the user.

C H E By using “Check: Test” function in the built-in self-diagnostic

PO I mode, you can check control panel, sensors, encoders function. Refer to Chapter 5, Adjustment, for more details.

INK LOW

†Problem

An ink end sensor has detected that the corresponding ink cartridge is almost empty (ever ink cartridge has an ink level gauge). It is possible to print about 100% duty on B1 size paper with the remaining ink, but the cartridge should be replaced as soon as possible.

If you re-install an ink cartridge that was detected as being in a “Near End” state, the status will immediately go to “Ink Out”. Only install new cartridges.

†Solution

Replace the ink cartridge.

C H E If for any reason you replace an ink cartridge before it reaches

PO I the ink-low or ink-out state with a new ink cartridge, you need to reset the ink counter using the control panel and Maintenance Mode 2.

PAPER OUT

†Problem

„Paper is not loaded.

„The rear edge of roll paper has been detected.

„The print job using cut sheets is finished or the rear edge of cut-sheet paper has been detected.

†Solution

„If paper has run out, remove the printer paper and load new paper. If print data remains in the printer, the data will be printed.

„If this error occurs even though paper is properly loaded, there may be something on the P-Rear sensor’s surface. Clean the sensor’s surface (hole in the Paper Guide, Upper) with a clean, dry cloth.

C A U Use a clean, dry cloth when cleaning sensors; never use a wet cloth or soap.

Troubleshooting General Errors 99