Epson 7000 service manual Version, Control Panel

EPSON Stylus Pro 7000 Revision B

VERSION

This function confirms the firmware version and dip switch settings.

[Pause] returns you to previous menu

[SelecType]

CONTROL PANEL

This function allows you to check the operation of the control panel buttons, LED indicators, and LCD panel.

[Pause] returns you to previous menu

[SelecType]

[Enter]

Ver. Firm XXXXXX

Ver. Parameter Pnl XXX

Ver. Parameter Moe XXXX

Ver. DipSW 0x03

16bit hexadecimal 0~FF

16bit hexadecimal 0~FF

ON: 0

OFF: 1

Panel: KeyPanel: Key XXXXXX

"XXXXXX" = name of pushed button

Panel: LCD

All dots = ON

Panel: LEDPanel: LED XXXXXX

"XXXXXX" = name of flashing LED

[Item]

[Pause] (press two times to exit "Panel: Key" function

Figure 5-5. Control Panel Check

Ver. Main Rev	XX
Ver. Panel Rev	01
[Item]

Figure 5-4. Version Menu Options

NOTE: The Dip switch

The dip switch located on the Main Board is a 2-bit switch, SW-1 is LSB (Least Significant Bit) and SW-2 is MSB (Most Significant Bit). For example, if JP1 = jumpered/ JP2 = jumpered, the LCD will display "Ver. DipSW 0x03".

†"Key" check

The name of the button that is pressed appears. Press the [Pause] button twice to exit the "Panel: Key" function.

†"LCD" check

All dots turn on. If a dot is not on, the LCD is not working properly.

†"LED" check

The LED indicators turn on in the following order and the name of the indicator appears on the LCD when that indicator turns on.

Power, Pause, Ink End (K, C, Lc, M, Lm, and Y), Paper Out, Roll Auto Cut, Roll Cut Off, and Sheet

Parameter Moe is for the mechanism version.

Adjustment Self-Diagnostic Mode Menus 167