Epson 7000 Adjustment Outline, Adjustment Tools, „ Before starting any adjustment procedure, find

EPSON Stylus Pro 7000 Revision B

5.1 Adjustment Outline

This section describes the adjustment procedures necessary after replacing certain parts and explains how to perform those adjustment procedures.

Before beginning any adjustment procedure, make sure of the following.

„Before starting any adjustment procedure, find the

C A U T I O N

adjustment procedure you need to perform in Table 5-2 on page 158 and verify the order or the tasks you need to perform.

„When performing an adjustment procedure, double-check the detailed instructions and caution information for that procedure; otherwise you may damage the printer.

„To make proper adjustment, make sure to avoid strong light (sun-light) around the printer. Since this printer uses photo-sensitive devices (photo-sensors), the printer may not function properly if it is operated under such conditions.

„When replacing the following, always install a new ink cartridge.

•Printheads

•Main Board

•"Holder, Assembly, Valve"

5.1.1 Adjustment Tools

The necessary tools for performing adjustment procedures on this printer are shown below.

Table 5-1. Adjustment Tools

Name	Part Code	Notes
Tension Gauge	1054053/standard	Max. 10,000g
	tool acceptable
Tension Gauge	B747700300/
	standard tool	Max. 2500g
#F712
	acceptable
Straight edge/ruler	1047746/ standard	Length: 1000mm
1000mm #F713	tool acceptable
Scale Stopper	1047745/ standard	Used in combination with #F713
#714	tool acceptable	(0.1mm scale)
	1050073	Type: 2MB Flash memory card
Flash Memory Card	standard	Standard: Type-II (PCMCIA Rel 2.1/
#F727	PC card	JEIDA Ver. 4.2)
	acceptable	Voltage: 5V Read/Write
Self-Training Kit	1053426	CD-ROM based service tool
#F733
Schema gauge	standard tool	0.6 & 0.7 mm
	acceptable
24 inch roll paper	EPSON special	Necessary for mechanism-adjustment
	media	printouts
	Kimoto brand:	Necessary to determine P_FRONT and
A3 Tracing paper	MicroTrace
		P_REAR sensor volumes
	#300LMB
A3 copy paper	standard paper	Necessary to determine P_EDGE
	acceptable	sensor volume
Transportation	1045585	For cleaning and transportation
liquid; S46 (x6)		purposes

Adjustment Adjustment Outline 157