Epson 7000 service manual Control Panel Messages, Paper Source Indicator, Display Message Meaning

EPSON Stylus Pro 7000 Revision B

1.4.2 Control Panel Messages

Table 1-28. Paper Source Indicator

Printer Status	Indicator
Selected paper source	On
Fatal error	Flashing
Roll paper and sheet sizes are different	Flashing
Reset, timer IC reset/NVRAM clear	On

Printer status and error messages appear on the control panel display. The table below lists the messages.

Table 1-29. Control Panel Messages

Display Message	Meaning
SERVICE REQ. nnnnnnnn	Fatal error - see “Service Requests” on
	page 48
TURN PWR OFF AND ON	Turn the printer off and on to reinitialize
RESET	In the process of re-initializing.
TRANSPORT PREP nn%	See “Transportation Mode” on page 53
POWER OFF	Preparing to shut down.
	The cover is open. The carriage stops in place,
COVER OPEN	and the printhead can be damaged if the head
	remains out of the capped position for a long
	period of time.
	Paper Set lever is in the released and cannot
SECURE PAPER LEVER	continue or begin a print, cleaning, or
	initialization sequence.
NO INK CARTRIDGE	One or more cartridges are not installed
OPTION I/F ERROR	An unsupported Type-B interface card is
	installed.
	• A predetermined amount of ink has been
	consumed after the cartridge has entered
INK OUT	the near-end condition.
	• A near-end cartridge has been removed and
	re-installed.

Table 1-29. Control Panel Messages (continued)

Display Message	Meaning
READY *	Can receive and print data.
	Resetting Timer IC
	Clearing NVRAM
WAIT *	Performing reset operation
	Performing ink sequence operation
	Initializing the printer
	Initializing the paper
INK CHARGING nnn%	Initial charging of ink - shown in percent
	completed
	Printer waits xx minutes before the next print
INK DRY xx MIN *	job to allow enough time for ink to dry on
	previous print job.
PRESS PAUSE BUTTON	Waiting for paper initialize start trigger
LOAD xxx PAPER	Wrong paper loaded or wrong paper source
	selected on control panel.
	The Paper Set Lever is in the released position
LOAD PAPER	(before printing). Pull the Paper Set lever
	forward to the set position
	Both front and rear paper sensors detect paper
	and there is a carriage over-current or out of
PAPER JAM	step error. This is due to:
	• Paper is jammed inside the printer
	• Paper is obstructing the carriage path
	during feeding or cutting operation.
PAPER NOT CUT	Printer did not cut the paper completely, or the
	cut piece still remains over the paper sensor
	Paper skewed more than 3mm between the
PAPER NOT STRAIGHT	leading and following edges. Check the
	printout for skew and make sure no ink was
	fired onto the platen.

Product Description Control Panel 37