Epson 7000 service manual Paper Skew, Correctly Load Paper

EPSON Stylus Pro 7000 Revision B

	Table 3-14. Paper Skew
Item	Description
LCD	Paper Skew
message
LED indicator	Paper Check indicator flashes.
status
	Paper skew error occurred.
	The lateral (horizontal) position of the leading edge and rear
	edge are off by over 3mm.
Details	When this error occurs, there is the possibility that ink has been
	fired onto the platen; make sure the platen is clean. Also, you
	may need to reprint your print job if the degree of skew is too
	much.
	Set the paper correctly to clear this error.
Recovery	Follow the directions in the user’s guide carefully. If the roll
	paper is curved or bent near the edge, line up the leading edge
	on both sides. If reloading the paper correctly does not clear the
	error, turn the printer off and back on.

	Table 3-15. Correctly Load Paper
Item	Description
LCD	Correctly Load Paper
message
LED indicator	Paper Check indicator flashes.
status
	There was a paper recognition error or cut sheet feeding error,
	which can happen under the following conditions:
	1) The user loaded the leading edge of the paper too far into the
	printer. The printer can only reverse feed the paper a set
	distance, and if the paper is loaded too far, it will not reverse
	feed far enough.
	2) The printer detected that the paper was loaded outside of the
Details	printable area/carriage path.
	3) After printing, the printer detected that the paper is outside of
	the cutting area/carriage path.
	4) The printer detected that the cut sheet loaded in the printer is
	too long/unsupported and could not be fully ejected. This may
	occur if roll paper is loaded but the control panel is set to cut
	sheets.
	5) This error may occur after a Paper Not Cut error.
	1-3 above) Correctly set the paper as described in the user’s
	guide. If the front edge is not clean and straight, cut it evenly.
	4-5 above) For roll paper cut off the section of the paper that has
	been ejected and properly reload the paper. For cut sheets eject
Recovery	the remaining paper and select Sheets on the control panel or
	load supported paper depending on the cause of the error.
	If after correctly reloading paper the same error occurs, check the
	operation and connection of the P-EDGE sensor located on the
	carriage.

Troubleshooting Troubleshooting Using the Error Messages 89