Epson 7000 service manual Cutter Housing Inner Face, Cutter Housing Outer Face

EPSON Stylus Pro 7000 Revision B

Do not tighten the four screws securing the cutter housing too

C A U T I O N

tightly. They can pull out the female screws on the carriage side, which warps the cutter housing. Since the encoder sensor is attached to the cutter housing, the encoder may have problems (trust me!).

If you run into the following or similar errors after replacing the cutter housing, loosen the screws a little and try again. Service Req. 0001000F

Service Req. 00010006

Hole shaped like

“T”; slide over

corresponding part

of carriage to

secure the cutter

housing

Cutter

guide

P_EDGE sensor

Figure 4-44. Cutter Housing Inner Face

Cutter guide

height lock

Cutter guide

Figure 4-43. Cutter Housing Outer Face

Cutter guide height lock Cutter guide

Cutter height

determined and

then screw

secured in factory

The up/down movement range is limited by the frame of the cutter guide height lock.

Faces the ink holder side

Figure 4-45. Cutter Height Determination (factory adjustment)

NOTE: The above cutter guide height adjustment is for your information and should not be necessary under normal circumstances.

Disassembly & Assembly Disassembly Flow 134