Epson 7000 service manual ADJ TOP & Bottom, Bottom margin Top margin Side Margin Feed Direction

EPSON Stylus Pro 7000 Revision B

ADJ TOP & BOTTOM

This function sets the distances between the P FRONT sensor and heads, cutter and heads, as well as the P EDGE sensor and heads. You can also use this function to adjust the top, bottom, and side margins.

1.	Make sure "Adj. Top & Bottom" appears, and press the Enter button.
2.	The printer prints a check pattern (lines) and cuts off the paper at a fixed
	distance.
3.	After the printing operation is finished, measure the top, bottom, and

Bottom margin

Top margin

Side

margin

Feed

direction

right (HP) side margins using a ruler. Press the item select (Paper Feed) +/

- buttons to enter each of these measurements in 0.1mm increments.

4. After entering the measurements, press the SelecType or Item button

until "Bottom Length xx.xmm" appears, and then press the Enter button.

Printing Pattern

Top Length 3.0mm

Figure 5-36. Measuring Sections/Margin Adjustment Pattern

Bottom Length	15.0mm
Side Margin	3.0mm
[SelecType]/[Item]

[Enter]

End

adjustment/

next menu

Figure 5-35. Margin Adjustment Operation

Adjustment Self-Diagnostic Mode Menus 190