Yazoo/Kees ZHDD61271, ZHDD72341 Replacing the Fuel Filter, Checking Tire Pressures, Radiator

Models: ZHDD61271, ZHDD72341

1 66
Download 66 pages 30.58 Kb
Page 39
Image 39
Replacing the Fuel Filter

MAINTENANCE

Replacing the Fuel Filter

 

 

 

 

 

The fuel filter is located with the priming pump.

 

 

 

 

 

Replace the fuel filter every 800 hours (once per

 

 

PRIMING PUMP

 

season) or more regularly if it becomes clogged.

 

 

 

 

 

Replace the filter as follows:

 

 

 

 

 

Unscrew fuel filter from pump and replace.

 

 

 

 

 

Every 50 hours check for water in the fuel filter.

 

 

 

 

 

Empty if necessary. Refer to the engine manual.

 

 

 

 

 

 

FUEL FILTER

 

 

 

 

 

Checking Tire Pressures

 

 

 

 

 

All four tires shall have a pressure of 16 PSI.

Fuel filter and fuel pump

 

 

 

BAM-18

 

 

 

 

 

Check and Filling Coolant System

WARNING!

ALWAYS make sure the engine is stopped and cool before remov- ing radiator pressure cap. To pre- vent scalding by hot fulid, NEVER remove the radiator cap while engine is hot.

NOTE: Failure to follow the recommended procedure for filling the cooling system will cause engine overheating and possible engine failure.

ALWAYS check coolant level at the overflow reservoir. The correct level of coolant in the over flow tank does NOT assure the radiator is full.

It is extremely important that when antifreeze is used, that it be mixed with water in a separate container before adding. NEVER add straight antifreeze to the radiator. Recommended mix is 50/50 lowtox (propylene glycol) phosphate-free antifreeze with tap water. DO NOT mix in ethylene glycol. Refer to engine operator’s manual.

The radiator for this cooling system is provided with two drain valves; one at each end of the lower tank. When draining the system, it is necessary to open both these valves to drain the radiator completely.

Add coolant to the radiator until it is up to the bottom of the fill cap. DO NOT install cap.

If the block has been drained, start and run the en-gine until the coolant level in the radiator drops. Stop engine.

Tire presssures

8011-564

 

Radiator

BAM-19

 

Add coolant to the bottom of the fill cap again. Install radiator pressure cap. Add coolant to the proper line on the over flow tank between FULL and LOW. Continued on next page.

39

Page 39
Image 39
Yazoo/Kees ZHDD61271, ZHDD72341 manual Replacing the Fuel Filter, Checking Tire Pressures, Check and Filling Coolant System