Yeoman YM-W9121FL, YM-W9122FL manual Fitting A New Glass Door, MAINTENANCE and SERVICING

MAINTENANCE and SERVICING

6.5Raise the other end of the baffle plate and attach the baffle extension tubes to the baffle pins, lower the baffle plate onto these tubes.

6.6Centre the baffle plate.

County (double depth, double sided models only) Two piece baffle

Support Pin
	Side Baffle Plate
Baffle Extension		Baffle Support
Tube			Bracket

PR7548

Front

PR7549

6.7To maintain efficient combustion the stove is fitted with a baffle in the top of the firebox.

6.8Allow the stove to cool fully before removing the baffle system.

6.9To fit the baffle, open the door and remove the log guard to give access to the firebox.

6.10Manoeuvre one of the baffle plates into the stove with the shorter flat area closest to you. Raise this edge up past the baffle pins and locate the rear edge on the baffle support bracket. Attach the baffle extension tubes and lower the front edge to rest on them.

6.11Repeat the operation from opposite side with second baffle plate.

6.12The removal of the system is the reverse of the previous operations.

6.13It is important to remove and clean the Baffle System to ensure the flue ways are clear of soot and debris and to ensure the safe and efficient operation of the stove. The frequency of cleaning will depend on the stove operating conditions.

6.14The baffle system is designed to give safe and efficient operation of the stove. Replace any damaged baffles immediately.

6.15Do not modify the baffle system.

7.FITTING A NEW GLASS DOOR

7.1To maintain the safe use of your stove you may need to replace a damaged door glass.

7.2To do this, remove the door, by opening and lifting the door free of the hinge blocks. Then lie the door face down on a soft flat surface, to protect the paintwork and glass.

Fixing Screws (x4)	1 Door
Fixing Clips (x4)

Glass

Glass Seal (3mm)

Door

PR7528

Fixing Screws (x8)	2 Door
Fixing Clips (x8)

Glass (x2)

Glass Seal (3mm)

Door (x2)

PR7529

7.3Using a screwdriver remove the glass clip fixing screws. The old glass can then be lifted clear of the door. (Note how the 3mm sealing rope is placed between the glass and the door.) Remember to dispose of the old glass safely.

7.4Clean, and re-paint, the rear of the door if required. Clean the screws with light oil and coat with high temperature anti-seize grease, this will aid future removal.

7.5Fit a new sealing rope between the new glass and the door, and place the glass into position in the door. Place the glass fixing clips into position and re-fix with the clean fixing screws, tighten the screws evenly until the clips hold the glass. Do not over tighten the clips as this could break the glass.

11