Chapter 13 Configuring the
Configuration Tasks
Serial6/0/0.16 is up, line protocol is up Hardware is
Internet address is 110.1.1.2/24
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec, reliability 255/255, txload 11/255, rxload 53/255
Encapsulation
Specifying the Interface Address on a SPA
SPA interface ports begin numbering with “0” from left to right.
•
•
•
For example, to configure the first interface (0) on a serial SPA installed in the first subslot of an MSC
(0) installed in chassis slot 3, use the the following command:
Router(config)# interface serial 3/0/0
The same slot/subslot/port format is used in similar commands for other
Optional Configurations
There are several standard, but optional configurations that might be necessary to complete the configuration of your serial SPA.
Note For additional command output details, see Chapter 18, “Command Reference” .
•Configuring Data Service Unit Mode, page 13-6
•Configuring Maintenance Data Link, page 13-8
•Configuring Scramble, page
•Configuring Framing, page 13-12
•Configuring Encapsulation, page
•Configuring Cable Length, page 13-14
•Configuring Invert Data, page
•Configuring the Trace Trail Buffer, page 13-15
•Saving the Configuration, page 13-17
Cisco 7304 Router Modular Services Card and Shared Port Adapter Software Configuration Guide
|
|
| |
|
|