Cisco Systems 7304 manual Configuring Maintenance Data Link, 13-8, Command, Purpose

Chapter 13 Configuring the 2-Port and 4-Port T3/E3 SPAs

Configuration Tasks

0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs Data in Interval 1:

0 Line Code Violations, 0 P-bit Coding Violation 0 C-bit Coding Violation

0 P-bit Err Secs, 0 P-bit Sev Err Secs

0 Sev Err Framing Secs, 0 Unavailable Secs

0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs

.

.

.

Configuring Maintenance Data Link

MDL messages are used to communicate identification information between local and remote ports. The type of information included in MDL messages includes the equipment identification code (EIC), location identification code (LIC), frame identification code (FIC), unit, Path Facility Identification (PFI), port number, and Generator Identification numbers.

Note C-bit framing has to be enabled in order to transport MDL messages between source and destination T3 ports.

To configure Maintenance Data Link (MDL), use the following commands.

Command	Purpose
Router# configure terminal	Enters global configuration mode.
Router(config)# interface serial slot/subslot/port	Selects the interface to configure.
	• slot/subslot/port— Specifies the location of the
	interface. See the: “Specifying the Interface
	Address on a SPA” section on page 13-5

Cisco 7304 Router Modular Services Card and Shared Port Adapter Software Configuration Guide

13-8 OL-4807-02