Cisco Systems 7304 manual Configuring Encapsulation, Verifying Encapsulation, frame-relay, 13-13

Chapter 13 Configuring the 2-Port and 4-Port T3/E3 SPAs

Configuration Tasks

Configuring Encapsulation

When traffic crosses a WAN link, the connection needs a Layer 2 protocol to encapsulate traffic. To set the encapsulation method, use the following commands:

Command	Purpose
Router# configure terminal	Enters global configuration mode.
Router(config)# interface serial slot/subslot/port	Selects the interface to configure.
	• slot/subslot/port— Specifies the location of the
	interface. See the: “Specifying the Interface
	Address on a SPA” section on page 13-5
Router(config-if)#encapsulation {hdlc ppp	Sets the encapsulation method on the interface.
frame-relay}	• hdlc—High-Level Data Link Control (HDLC)
	protocol for serial interface. This is the
	default.
	• ppp—PPP (for serial interface).
	• frame-relay—Frame Relay (for serial
	interface).

Verifying Encapsulation

Use the show interfaces command to display the encapsulation method:

router# show interfaces serial 6/0/1 Serial6/0/1 is up, line protocol is up

Hardware is SPA-4T3E3

MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec, reliability 255/255, txload 223/255, rxload 222/255

Encapsulation FRAME-RELAY, crc 16, loopback not set Keepalive set (10 sec)

LMI enq sent 13076, LMI stat recvd 13076, LMI upd recvd 0, DTE LMI up LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0

LMI DLCI 0 LMI type is ANSI Annex D frame relay DTE FR SVC disabled, LAPF state down

Broadcast queue 0/256, broadcasts sent/dropped 0/0, interface broadcasts 0 Last input 00:00:04, output 00:00:04, output hang never

Last clearing of "show interface" counters 1d12h

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 38579000 bits/sec, 109611 packets/sec

5 minute output rate 38671000 bits/sec, 109852 packets/sec

14374551065 packets input, 632486376132 bytes, 0 no buffer Received 0 broadcasts (0 IP multicast)

0 runts, 0 giants, 0 throttles

0 parity

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 14408526130 packets output, 633974757440 bytes, 0 underruns 0 output errors, 0 applique, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

rxLOS inactive, rxLOF inactive, rxAIS inactive txAIS inactive, rxRAI inactive, txRAI inactive

	Cisco 7304 Router Modular Services Card and Shared Port Adapter Software Configuration Guide
OL-4807-02		13-13