Cisco Systems 7304 Configure the Interface, Verifying Controller Configuration, Internal line

Chapter 13 Configuring the 2-Port and 4-Port T3/E3 SPAs

Configuration Tasks

Configure the Interface

To set the ip address for the 2-Port or 4-Port T3/E3 SPA, complete these steps:

	Command	Purpose
Step 1	Router(config)# interface serial	Selects the interface to configure and enters interface
	slot/subslot/port	configuration mode.
		• slot/subslot/port— Specifies the location of the interface. See
			the: “Specifying the Interface Address on a SPA” section on
			page 13-5
Step 2	Router(config-if)# ip address	Sets the IP address and subnet mask.
	address mask	•	address—IP address
		•	mask—Subnet mask
Step 3	Router(config-if)# clock source	Sets the clock source to internal.
	{internal line}	• internal—Specifies that the internal clock source is used.
		• line—Specifies that the network clock source is used. This is
			the default.
Step 4	Router(config-if)# no shut	Enables the interface.
Step 5	Router(config)# exit	Exits configuration mode and returns to the EXEC command
		interpreter prompt.

Verifying Controller Configuration

Use the show controllers command to verify the controller configuration:

router# show controllers serial 6/0/0 Serial6/0/0 -

Framing is c-bit, Clock Source is Line

Bandwidth limit is 44210, DSU mode 0, Cable length is 10 rx FEBE since last clear counter 2, since reset 0

Data in current interval (546 seconds elapsed):

0		Line Code Violations, 0	P-bit Coding Violation
0		C-bit Coding Violation
0		P-bit Err Secs, 0 P-bit Sev Err Secs
0		Sev Err Framing Secs, 0 Unavailable Secs
0		Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs
	Data	in Interval 1:
0		Line Code Violations, 0 P-bit Coding Violation
0		C-bit Coding Violation
0		P-bit Err Secs, 0 P-bit Sev Err Secs
0		Sev Err Framing Secs, 0 Unavailable Secs
0		Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs
.
.
.
	Data in Interval 44:
0		Line Code Violations, 0 P-bit Coding Violation
0		C-bit Coding Violation
0		P-bit Err Secs, 0 P-bit Sev Err Secs
0		Sev Err Framing Secs, 0 Unavailable Secs
	560 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs
	Total Data (last 44 15 minute intervals):
0		Line Code Violations, 0 P-bit Coding Violation,
		Cisco 7304 Router Modular Services Card and Shared Port Adapter Software Configuration Guide
	OL-4807-02			13-3