York B1HP024 THRU 048 manual Description, Standard Features / Benefits, Factory Mounted Txv

036-21528-001-A-0303

®

DESCRIPTION

These packaged heat pumps are designed for outdoor installation. Only utility and duct connections are required at the point of installation.

Field-installed electric heater accessories are available to provide electric heat, if required.

STANDARD FEATURES / BENEFITS

OPERATING EFFICIENCY

All units provide high operating efficiencies of 13 SEER, 3.3 COP or greater, and 7.6 HSPF. All efficiencies exceed leg- islated minimum levels.

ON SITE FLEXIBILITY

All model sizes share a common, compact design cabinet with a single footprint. The installer has the flexibility of set- ting one curb or pad and placing the proper tonnage unit after the internal load has been determined. Field convert- ible duct connections, from side shot to down shot, allows the installer greater flexibility and the need to carry less inventory.

LOWER INSTALLATION COST

Installation time and costs are reduced by easy power and control wiring connections. The small base dimension means less space is required on the ground or roof. Plus, the installer can fit this unit between the wheel wells of full size pick-up truck. All models are under 500 pounds.

CHAMPIONÆPLUS

SINGLE PACKAGE

HEAT PUMPS

B1HP024 THRU 048

2 THRU 4 NOMINAL TONS

13 SEER

FACTORY MOUNTED TXV

All units are completely wired, charged with R-22 and tested prior to shipment. Unique test stations, are used to insure product quality. Refrigerant charge, and component part numbers are verified via computers at manufacturing point. Vital run test statistics, such as, system pressure, motor currents, air velocity and temperature unit vibration are monitored and recorded by the system to insure unit performance.

Equal size, side supply and return duct connections allow easy hook-up of ducts to match low crawl spaces without transition pieces.

UTILITY CONNECTIONS MADE EASY

Electrical utility knockouts are provided through the bottom, as well as the side of the unit. Utility connections can be made quickly and with a minimum amount of field labor. A field supplied and field installed electrical disconnect switch must be installed.

CONVERTIBLE AIRFLOW DESIGN

The bottom duct openings are covered when they leave the factory. They are ready for a side supply / side return appli- cation. If a bottom supply / bottom return application is desired, you simply remove the two panels from the bottom of the unit and place them in the side supply / side return duct openings. No panel cutting is required and no acces- sory panel is necessary. Convertible airflow design allows maximum field flexibility and minimum inventory.

FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE