PROTECTED COMPRESSOR
The compressor is internally protected against high pressure and temperature. This is accomplished by the simultaneous operation of high pressure relief valve and a temperature sensor which protects the compres- sor, if undesirable operating conditions occur.
EXCLUSIVE COIL DESIGN
Grooved copper tubes and enhanced aluminum fin construction improves heat transfer for maximum effi- ciency and durability.
LOW MAINTENANCE
Long life, permanently lubricated condenser and evap- orator fan motor bearings, need no annual mainte- nance. Blower assembly can be easily cleaned by the unique “Slip Track”
SECURED SERVICE ACCESS PORTS
Protected, externally mounted,
EASY SERVICE ACCESS
A large, single hinged panel covers the electrical con- trols and makes servicing easy. The blower compart- ment has an additional large panel with a
REPLACEMENT PARTS
The installer has no need to carry an inventory of unique parts or needs special training to replace any of the components parts for these units. All are easily obtained from Source 1 or other major part houses.
FIELD-INSTALLED ACCESSORIES
ECONOMIZER DOWN DISCHARGE / SUPPLY KIT
Modulating integrated economizer provides simulta- neous operation between the mechanical cooling and economizer operation. Independent blade design insures proper control and less than 1% leak rate. Includes hood and mesh bird screen filter integrated into the hood, dry bulb sensor and relief damper. Sepa-
rate field accessories of single enthalpy and dual enthalpy are also available.
SINGLE ENTHALPY SENSOR
Sensor replaces dry bulb sensor standard in econo- mizer kit. Provides improved economizer operation by sensing the dry bulb temperature from outdoors, plus the enthalpy content of the outdoor air.
DUAL ENTHALPY SENSOR
Additional sensor to single enthalpy sensor. Sensor selects both the return air temperature dry bulb and humidity, in conjunction with the single enthalpy, to determine the most economical mix. Single Enthalpy sensor also required.
UPGRADE PRESSURE PACKAGE
Contains screw in type High pressure, Low Pressure/ Loss of Charge switch, freeze protection switch and lockout relay. Switches are placed onto existing Schrader ports located in the unit by furnished adapt- ers. When abnormal conditions are sensed through the pressure switches, the unit will lock out, preventing any further operation until reset or problem is corrected. Package agency approved.
HAIL GUARD KIT
Kit contains protected grilles made of expanded alumi- num grilles with full perimeter
FILTER / FRAME KIT (SINGLE PHASE ONLY)
Kit contains the necessary hardware to field install return air filters into the base unit.
MOTORIZED FRESH AIR DAMPER
Designed for duct mounted side return and unit mounted down shot return applications. Damper capa- ble of providing 0% thru 50% of outdoor air (field sup- plied). Closes on power loss, includes hood and screen assembly.
Unitary Products Group | 3 |
