1 | 2 |
ON
POWER
SUBWOOFER
LEVEL
+3 +10
0 +20
3
INPUT GROUND
ES200P
DESIGNED & MANUFACTURED BY YORKVILLE SOUND • TORONTO, CANADA
230V |
| 120V |
50Hz |
| 60Hz |
1.1A | Yorkville | 2.2A |
CAUTION: REPLACE WITH
SAME TYPE FUSE AND RATING
ATTENTION: UTILISER UN FUSIBLE DE
RECHANGE DE MEME TYPE ET CALIBRE
T 1,25A L
GROUNDED
UNGROUNDED
INPUT LEVEL
SPEAKER
LINE
I N P U T
PARALLEL
THRU
POWER
6
4
5
INTRODUCTION
The ES200P powered subwoofer incorporates a 200 watt amplifier. It can be used to enhance the bottom end (bass) of a
The ES200P also has a built in limiter and thermal protection that make this product
smooth and robust at high power levels. The internal limiter and the internal protection are factory set to maximize performance.
1.Power Switch
2.Volume
Set the volume control to a desired level as music is being played through the unit.
A setting of 0 dB on the SUBWOOFER LEVEL control is the correct starting point when setting up a sound system. From there the sound can be adjusted for best sound. The 0 dB mark refers to the setting that will give full power when the line input is used and the input signal is at a level of +4 dBV. This also is the setting to give a sensitivity of 2.83 Vrms (1 watt 8- ohms) for 100 dB spl when set for speaker level input. With a typical full range companion speaker this will give flat response. In either line or speaker operation it will usually be desireable to set the control at +3 to +6 to give some bass boost at low power levels. At levels approaching full power the
3. Input Level Switch
Speaker
Normally, the input to the subwoofer is from a
(See figure 2.0)
Line
In this case, the input to the subwoofer is from a line level source such as a mixer.
4. Ground Lift
If a hum, or buzz is detected from the subwoofer, try setting the switch to the GND LIFT position (OUT position). The switch should otherwise be left in the GND (IN position).
5. Input Jacks
The two inputs are balanced
1
