Manuals / Z-Com / Computer Equipment / Network Router

Z-Com R1 Extender manual System Installation, Page

Models: R1 Extender

1 20

Page 11

Warning:

Make sure PoE is correctly connected to the RJ-45 port on the R1 Extender labeled PoE+Data. DO NOT connect to the port labeled “Warning!! No POE”, otherwise the extender will be severely damaged!

Chapter 3 System Installation

Page 11

Image 11

Z-Com R1 Extender manual System Installation, Page

Contents

R1 Extender Quick Installation Guide V1.0 JanuaryConventions About the Installation GuideCopyright Introduction Chapter 1 IntroductionSafety Precautions Chapter 2 Preparation before InstallationProfessional Installation Required Fasteners Product PackageMounting Kit Wall/Pole Mounting Bracket11. Wall/Gyprock Plug ×4 for Wall Mount Waterproof RJ-45 Connector KitChapter 2 Preparation before Installation 10. Wood Screw ×4 for Wall MountAssemble the Mounting Bracket Chapter 3 System InstallationPole Mounting Slide the Sealing Nut from its Breach Connect UpPower On Ground the wirePage Chapter 3 System InstallationConnect the R1 Extender to a Local Computer Chapter 4 ConfigurationPage Chapter 4 ConfigurationR1 Extender’s still initializing System ready TTL time may vary depending on the operating systemHow to Establish Wireless Bridge Mode 192.168.1.2 and set the IP Subnet Mask on both as Login the Web-based interface of remote R1 Extender, open “About” in “System” and record the wireless MAC address of it Use ping to check whether the link between the two R1 Extender is OK both R1 Extenders are installed long distance apart Q 1.What if my R1 Extender fails to connect to the remote one? Chapter 5 TroubleshootingQ 2.What if I would like to reset the unit to default settings? sales@zcomax.com Chapter 6 Service Informationinfo@zcom.com.tw support@zcom.com.tw