Manuals / Z-Com / Computer Equipment / Network Router

Z-Com manual R1 Extender’s still initializing System ready, Configuration, Page

Models: R1 Extender

1 20

Download 20 pages 49.4 Kb

Page 13

R1 Extender’s still initializing

R1 Extender’s still initializing

System ready

Note:

Considering convenient configuration, it is recommended to configure local and remote R1 Extender respectively on two computers.

TTL time may vary depending on the operating system.

Chapter 4 Configuration

Page 13

Image 13

Z-Com R1 Extender’s still initializing System ready, TTL time may vary depending on the operating system, Configuration

Contents

R1 Extender Quick Installation Guide V1.0 JanuaryCopyright About the Installation GuideConventions Introduction Chapter 1 IntroductionProfessional Installation Required Chapter 2 Preparation before InstallationSafety Precautions Mounting Kit Product PackageWall/Pole Mounting Bracket FastenersChapter 2 Preparation before Installation Waterproof RJ-45 Connector Kit10. Wood Screw ×4 for Wall Mount 11. Wall/Gyprock Plug ×4 for Wall MountAssemble the Mounting Bracket Chapter 3 System InstallationPole Mounting Slide the Sealing Nut from its Breach Connect UpPower On Ground the wirePage Chapter 3 System InstallationConnect the R1 Extender to a Local Computer Chapter 4 ConfigurationR1 Extender’s still initializing System ready Chapter 4 ConfigurationTTL time may vary depending on the operating system PageHow to Establish Wireless Bridge Mode 192.168.1.2 and set the IP Subnet Mask on both as Login the Web-based interface of remote R1 Extender, open “About” in “System” and record the wireless MAC address of it Use ping to check whether the link between the two R1 Extender is OK both R1 Extenders are installed long distance apart Q 2.What if I would like to reset the unit to default settings? Chapter 5 TroubleshootingQ 1.What if my R1 Extender fails to connect to the remote one? info@zcom.com.tw Chapter 6 Service Informationsupport@zcom.com.tw sales@zcomax.com