Zanussi AG125 quick start For the installer, Connecting to the mains, Electrical connections

ZM 24ST GB

For the installer

1.Remove any promotion label from the door.

2.This oven can be used as a free standing oven or built-in, into a kitchen cabinet using kit number BF246, which is ordered separately. To install the oven in a kitchen cabinet follow the instructions supplied with the building-in kit.

The oven should be installed on a flat, level surface. The surface must be strong enough to safely bear the weight (18 kg) of the oven, and the contents. To avoid the possibility of causing vibration or noise the oven must be in a stable position.

3.Keep the oven away from heat and water. Exposure to heat and water can lower oven efficiency and lead to malfunctioning, so be sure to install the oven away from heat and water sources.

4.If using the appliance as a free-standing appliance do not block air vents on the top and the sides of the cabinet and also do not place any articles on the top of the oven. A gap all around the oven is necessary : 140 mm above the oven and any objects, 50 mm on the sides and 100 mm behind the oven. If air vents are blocked during operation the oven may overheat, and this may lead to mal- functioning. Hot air escapes from the vents, so be sure not to obstruct them or let curtains come be- tween the oven and the rear wall.

5.Place the oven as far away from radios and TVs as possible. This oven does conform to EEC require- ments of radio interference suppression, but some interference may occur if it is placed too close to a radio or TV, so keep them as far apart as possible.

Connecting to the mains

The oven is delivered with the power cord and a plug for 240 V, 50Hz, earthed socket outlet.

Earth protection minimizes the risks should a short- circuit occur. Check to ensure the voltage of the oven matches the supply.

N.B. If the oven is connected to the socket via an extension cord, make sure the cord is earthed.

This appliance must not be used on a non-earth

!protected power supply. Contact an electrician if you are uncertain regarding electricial connection of the oven or provision of earth protection of the supply.

This appliance must be earthed. If this appliance is fitted with a non-rewirable plug for which your socket is unsuitable, the plug should be cut off and the appropriate plug fitted. If it is necessary to change the fuse in a nonrewirable plug, the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not be used until a replacement is obtained.

Electrical connections

THIS APPLIANCE MUST BE EARTHED. ! The manufacturer declines any liability should this safety measure not be observed.

50