...the wash results are not satisfactory
The dishes are not clean
●The wrong washing programme has been selected.
●The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded.
●The spray arms do not rotate freely due to wrong arrangement of the load.
●The filters in the base of the washing compartment are dirty or incorrectly positioned.
●Too little or no detergent has been used.
●Where there are limescales deposits on the dishes; the salt container is empty or the wrong level of the water softener has been selected.
●The drain hose connection is not correct.
●The salt container cap is not properly closed.
The dishes are wet and dull
●Rinse aid was not used.
●The rinse aid dispenser is empty.
There are streaks, milky spots or a bluish coating on glasses and dishes
●Decrease rinse aid dosing.
Water drops have dried onto glasses and dishes
●Increase rinse aid dosing.
●The detergent may be the cause. Contact the detergent manufacturer’s consumer care line.
If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher’s door (see picture).
So that you always have these numbers at hand, we recommend you to make a note of them here:
Mod. : . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . .
RA08 |
9
