Service
Service and Spare Parts
In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning:
08705 929929
Your telephone call will be automatically routed to the Service Force Centre covering your post code area.
For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.uk
Before calling out an engineer, please ensure you have read the details under the heading ”In the event of a fault”.
When you contact the Service Force Centre you will need to give the following details:
1.Your name, address and post code
2.Your telephone number
3.Clear and concise details of the fault
4.The model and serial number of the appliance (found on the rating plate)
5.The purchase date
Customer Care Department
For general enquiries concerning your Zanussi appliance or for further information on Zanussi products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.zanussi.co.uk
Customer Care Department
Zanussi
Slough
Berkshire
SL1 1DZ
Tel: 08705 727727 *
* call to this number may be recorded for training purposes.
Please note that a valid purchase receipt or guarantee documentation is required for
Never attempt to repair the dishwasher yourself. Repairs carried out by unauthorized or inexperienced persons can cause injury or serious malfunctioning.
Information for test centres
The salt container and rinse aid dispenser shall be filled in accordance with this instruction manual.
Before conducting the measurements the dishwasher shall be operated for one or two complete cycles using detergent and a clean load.
Test standard: | EN 50242 och EN 60704 |
|
|
Rated capacity: | 6 place settings accordance EN 50242 |
|
|
Loading of basket: | accordance figure on page 10 |
|
|
Test program: | energy saving 55° C |
|
|
Detergent (IEC type B): | 15 gram in the dispenser + 3 gram in the |
|
|
Rinse aid (type III): | setting 3 |
|
|
Feed water pressure: | minimum 0,8 bar, maximum 10 bar |
- 13 -
