Using the appliance
Starting the programme
1. Scrape or rinse off solid food remnants.
2.Load the dishwasher.
(See the basket and loading in page 10).
3.Put the correct amount of detergent into the detergent dispenser and close the dispenser lid.
4.Close the door.
5.Press in the On/Off button.
6.Press in the required programme button (see pro- gramme chart). Programme indicator lamp is lit. During the six seconds the two top indicator lamps are flashing, you can select another programme cycle. If not, the selected programme starts.
The lamp indicates which part of the selected cycle the dishwasher is in.
7.Check the strainers/filters to see if they need to be cleaned when the dishwasher has finished the programme.
If both the top and middle indicator lights are flashing, first check that the door is properly closed, if it is read the section ”Something Not Working”.
Pause function
With the pause function the programme can be temporarily disrupted for a short period of time.
1. Press in the On/Off button. The programme stops.
2.All lamps goes out.
3.When you want the programme to continue again, you press the On/Off button.
The programme continues.
The programme should not be paused for any longer than necessary, because the water inside the dishwasher has cooled down and must be heated again which increases the power consumption.
Cancelling the drying phase
In case you do not want to wait until the drying phase is completed, you can cancel it.
1. Press in the On/Off button. The control lamp for the On/Off button goes out.
2. Open the door. The drying phase is cancelled.
Stopping the programme temporarily
1. Open the door. The programme stops.
2.Top or middle indicator lamp is flashing depending on how far the programme cycle has gone.
3.Close the door and the programme continues after about 6 seconds.
Open the door carefully when the dishwasher is running, since hot steam may escape.
Cancelling the programme
1. Press and hold in the button for the programme in progress until the indicator light for the pro- gramme goes out.
2.Release the programme button. The programme is now cancelled and a new programme can be selected.
If you switch the dishwasher off, the selected programme is not finished, it is only paused. When you start the dishwasher again, the pro- gramme will continue.
Switching the dishwasher off
Do not switch the dishwasher off until the indicator lamp for the programme cycle end is lit.
1. Press in the On/Off button. The control lamp for the On/Off button goes out.
Be careful if you open the door immediately after the programme is finished, since hot steam may escape.
This dishwasher has a new feature called ”IMPULSE WASHING”. This washing system varies both the revolutions of the pump and the water pressure for more intensive cleaning of the dishes during a programme. That is why different sections of the programme cycle do not sounds the same.
- 9 -
