Zanussi DE 6755 manual Filling with salt, Rinse aid, Filling with rinse aid, To fill

Filling with salt

Only use salt specifically designed for use in dishwashers.

All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener.

Only fill with salt just before starting one of the washing programmes.

This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time, which may cause corrosion.

Rinse aid

Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting.

Filling with rinse aid

1. Open the container by turning the lid (A) anticlockwise.

2. Add the rinse aid until the container is completely full.

The indicator (B) will be completely dark.

To fill:

3. Top up the rinse aid when the rinse aid indicator light on the

control panel illuminates.

1. To fill with salt, unscrew

the cap of the salt

container.

2. Pour 1 litre of water inside

the container (this is

necessary only before

filling with salt for the first

time).

3. Using the funnel provided,

pour in the salt until the

container is full.

SALET

SAL

SALZ

SEL

BR01

BR03

Do not worry if water over

flows from the unit when

filling with salt, this is quite normal.

SR06

If rinse aid refilling is necessary, the rinse aid indicator light will illuminate only in setting mode and at the end of the washing programme.

4.Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket.

5.Screw on the cap tightly.

The salt container will require topping up periodically.

You are reminded of this by the salt indicator light on the control panel which comes on when the salt has finished.

The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched

on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected.

During the run of the programme it will remain off.

Ensure that the lid is closed after every refill.

Do not put liquid detergent in the rinse aid compartment. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash.

It is possible to deactivate the rinse aid indicator light (see the following instructions).

By default the rinse aid indicator light is active.

To deactivate the rinse aid indicator light ensure that the dishwasher is off and then proceed as follows:

1. Press	INTENSIVE SID 80				I and NORMAL	programme push
buttons simultaneously.
2. While keeping the programme push buttons						INTENSIVE
SID 80	I	and	NORMAL		pressed switch on the dishwasher by
pressing the			ON-OFF		push button.
The	ON-OFF		indicator light comes on.
At the same time, the indicator lights of the						INTENSIVE SID
80 I and		NORMAL		push buttons start flashing.

SO507
3. Press the	NORMAL	push button, the correspondent
indicator light keeps flashing while the indicator light of the
INTENSIVE SID 80		I push button turns off. At the same time
the indicator light		end of programme	starts to flash.

6