Starting a washing programme
1.Check that the baskets have been loaded correctly and that the spray arms can rotate freely
7. End of the washing programme
The dishwasher will automatically stop and the end of programme phase indicator light (END) will illuminate.
The indicator light of the programme just ended will remain on.
2.Turn on the water tap
3.Close the dishwasher door
4.Press the On/Off push button
The On/Off indicator light will come on.
5. Setting and starting the programme
Press the push button corresponding to the required programme (see "Washing programmes" chart). The indicator light corresponding to the programme and the phase indicator lights foreseen for that programme will illuminate.
If you want to select the half load option, press the corresponding push button.
After about 3 seconds from the last pressure of a push button the programme starts automatically.
Once the programme has started the phase indicator lights will turn off except for the phase under way.
Note: it is possible to select a washing programme also with the door slightly opened.
In this case the start of the programme will occur after about 3 seconds from the closure of the door.
a)Press On/Off push button.
b)Select a washing programme.
c)Close the door.
The programme will start automatically after about 3 seconds from the closure of the door.
If the door is not immediately opened at the end of the programme, air will circulate inside the dishwasher to prevent residual steam recondensing on the dishes as water droplets.
This device operates intermittently for about 20 minutes, as long as the dishwasher is switched on.
if the On/Off push button is pressed or the door is opened during these 20 minutes, the device will be automatically cancelled.
Switch off the dishwasher by pressing the On/Off push button, the On/Off indicator light turns off.
Open the door and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved.
Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes.
Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance.
Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
6. To interrupt or cancel a washing programme in progress
Interrupt or cancel a washing programme in progress ONLY if it’s absolutely necessary.
Attention! Hot steam may escape when the door is opened. Open the door carefully.
To interrupt a washing programme in progress
a)Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point in which it was interrupted.
b)Press the On/Off push button (in this case all the indicator lights turn off). Press the On/Off push button again; the programme will start from the point in which it was interrupted.
To cancel a washing programme in progress
To cancel a washing programme you have to reset the dishwasher; press simultaneously the function push buttons 2 and 3 until all the indicator lights will
turn off (except for the On/Off indicator light and eventually the rinse aid and salt indicator lights) indicating that the running programme has been cancelled.
13
