Operating sequence
1.Check the filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning").
2.Press the ON-OFF push
button
The
3.Check that there is rinse aid
and salt
The corresponding indicator lights will illuminate if refilling is necessary.
4.Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5.Ensure that the spray arms can rotate freely.
6.Measure out detergent
Add the required amount of detergent into the dispenser according to the recommended quantity given in the Washing programmes chart.
Important!
If the half load option is selected remember to reduce the quantity of detergent.
Close the detergent dispenser lid.
The setting of the programme is possible:
With the door open, | in this case the selected |
programme and eventual options will start | |
automatically 5 seconds after the closing of the | |
door. |
|
With the door closed, | in this case the |
selected programme and eventual options will | |
start automatically 5 | seconds after the last |
pressure of a push button.
7a. Setting and starting the programme without delay startPress the push button corresponding to the required programme: in the digital display will appear the time duration in minutes of the programme and the phase indicator lights for that programme will illuminate.
Select, if required, the HALF LOAD option. The corresponding indicator light will illuminate
and the duration of the programme in the digital display will be confirmed.
If the setting has been made with the door open, close the door and the programme will start automatically after 5 seconds.
Until the door remains opened it is possible to change the setting.If the setting has been made with the door closed, the programme will start automatically 5 seconds after the last pressure of a push button.
The start of the programme will be confirmed
by an audible signal, the phase indicator lights will turn off except for the phase under way. The duration of the programme visible in the digital display will start to decrease from minute to minute.
7b. Setting and starting the programme with delay startOnce a programme and required options |
| ||
have been selected (see point 7a) | to set the | ||
delay start proceed as follows: |
| ||
Press the | DELAY | push button, in the digital | |
display will appear | h 1. |
|
16