In case that plates are loaded in the upper basket:
load them starting from the rear positions of the basket; tilting them slightly forwards and avoiding the front positions near the door.
US71 |
Adjusting the height of the upper basket
If washing very large plates (over 27 cm and up to 32 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position.
To move to the higher position proceed as follows:
1.Pull out the basket until it stops.
2.Carefully lift both sides upwards until the mechanism is engaged and the basket is stable.
When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks.
To lower the basket to the original position proceed as follows:
1.Pull out the basket until it stops.
2.Carefully lift both sides upwards and the allow the mechanism to drop back slowly, keeping hold of it.
Never lift or lower the basket on one side only.
After loading your machine always close
the door, as an open door can be a hazard.
RC04 |
12
