UNPACKING AND INSTALLATION
TRANSIT SECURITY BARS
Before starting the machine up, the transport security bars must be removed as follows:
You are advised to keep all the transport security bars in case the appliance has to be transported again.
1. Unscrew and remove the three rear screws by means of a key.
2. Lean the appliance back on the rear and fit one of the polystyrene angles between the appliance and the floor.
Make sure the hoses are not squashed.
3. Carefully remove the plastic bags on the right and the left, pulling them to the centre of the appliance.
4. Place the machine in an upright position and remove the three plastic bolts.
5. Plug the 3 holes with the plastic plugs which you can find in the envelope containing the instruction booklet.
HYDRAULIC CONNECTION
There should be a COLD WATER tap near the washing machine with a screwing on connection pipe of 3/4 gas for the water supply, a sink, a wash basin or a drainage system in the wall.
Previously check if:
Ñit is not a hot water tap.
Ñthe running water is clean. If not, run off a reasonable amount of water to flush out any debris that may have collected in the pipes.
Have the permanent drainage system in the wall checked by a plumber.
Place the enclosed rubber joint, delivered in a plastic bag together with the appliance (A) Fig.6), at the very end of the inlet hose and carefully screw the pipe to the tap taking care not to damage the screwdrive and fix the nut well on to the end in order to avoid leaking.
If necessary turn the hose adequately by unscrewing the nut at the rear of the appliance.
Now tighten the nut anew to avoid leaks. (Open the tap and asure that it does not leak and close it again.)
Place the discharging hose in a washbasin or sink with the aid of the bent piece delivered separately. The bent piece has to be entered into the tubeÕs mouth in order to assure the support. Aforesaid piece allows the hose to be fixed to the wall by means of an opening on the upper part and that way the hose does not move and its falling is avoided.
24
