KTo Remove/Replace the Charcoal Filter
1.Open the visor.
2.Remove the metal grease filters.
3.Remove one filter at a time by placing one hand over the filter and releasing the spring retaining clip.
4.Allow the filter to hinge back and then remove.
Worktop lighting
If the fluorescent strip lamp fails to function first check to ensure that the pins are located into the holder.
KReplacing the strip light
1.Remove the lighting diffuser screws, through the end capping on the right hand side.
2.Slide the diffuser to the left until the opposite end is free, then pull the diffuser down.
3.Remove the fluorescent tube and replace with one of the same specification.
4.Replace the cover and the retaining screws.
KReplacing the strip light starter
1.Open the visor and remove the grease filter cassette.
2.Unscrew the two fixing screws which secure the internal cover immediately in front of the lighting diffuser, on the inside edge of the casing.
3.Lift the cover from the bottom to remove.
4.Rotate the starter
7
