Unpacking

Before installing the machine the packing and transit bolts must be removed. The transit packaging is red for ease of identification. Please retain the packing and transit bolts for re-use in case the machine is to be transported again.

Unpack the appliance. Tilt the appliance backwards. Remove the polystyrene base, by turning the appliance one quarter turn.

Remove the base (fig. 1).

Open the lid and remove the polystyrene block and wedges securing the drum.

Close the lid (fig. 2).

Using a spanner, remove the two transit bolts (A) (fig. 3).

The holes which are now visible must be filled with the plugs (B) provided (fig. 4).

Retain the polystyrene block and transit bolts for future use (fig. 5).

To enable the appliance to be pushed further into the recess, the plastic crossbar holding the hoses at the back of the appliance can be cut off (fig. 6).

Positioning

The installation surface must be clean dry and level

Do not install on deep pile carpet.

Do not install the appliance in locations where the temperature may fall below freezing Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown

Fig. 1

A

Fig 3

Fig 5

Fig. 2

B

Fig 4

Fig 6

21

Page 20
Image 20
Zanussi 434, Washer, TJS1397W manual Unpacking, Positioning