THE CERAMIC HOB
Do not use the appliance if the ceramic glass is damaged. If a fault or crack becomes visible during cooking, disconnect the appliance immediately from the electricity supply and contact your local Service Force Centre.
USING THE HOB
Turn the control knobs in either direction to vary the heat setting.
The highest number represents the hottest setting and the lowest number represents the coolest setting.
RECOMMENDED SAUCEPANS
Only saucepans with flat bases and close fitting lids are recommended. The saucepan base should be approximately the same size as the cooking area.
Ensure that new saucepans are well scrubbed to remove edges and take off any deposits left from manufacture.
Traditional round bottomed Woks must not be used even with a stand. Woks with
NOTE:
Occasionally the heated areas may be seen to switch ON and OFF when higher heat settings are being used. This is due to a safety device which prevents the glass from overheating.
Some switching ON and OFF when cooking at high temperatures, e.g. deep fat frying is quite normal, causes no damage to the hob and little delay in cooking times.
Excessive switching may however be caused by the use of an unsuitable saucepan or a saucepan which is smaller than the heated area. If excessive switching occurs, discontinue use of the saucepan.
4
2
0
10
