Operation
INSTALLATION
Any gas installation must be carried out by a CORGI registered installer, and in
accordance with existing rules and regulations.
The relevant instructions are to be found in the second section of this manual.
Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown.
WHEN THE COOKER IS FIRST INSTALLED
Once the cooker has been installed, it is important to remove any protective materials, which were put on in the factory.
Controls
Hob burners
To light a burner, turn the relevant control knob anticlockwise to maximum position. At the same time push the electric ignition button which is marked with a little spark. Then adjust the flame as required.
If the burner does not ignite, turn the control knob to zero, and try again.
i | When switching on the mains, after | |
installation or a power cut, it is quite normal | ||
| ||
| for the spark generator to be activated | |
| automatically. |
To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used (see table).
Burner | minimum | maximum |
| diameter | diameter |
|
|
|
Large (rapid) | 180 mm. | 260 mm. |
Medium | 120 mm. | 220 mm. |
Small (Auxiliary) | 80 mm. | 160 mm. |
|
|
|
i
If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the pan, causing the handle to overheat.
As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering.
Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite.
If the control knobs become difficult to turn, please contact your local Zanussi Service Force Centre.
6
