Electric Oven
Oven Function Control Knob
Oven Light - The oven light will be on without any cooking function
Defrost Setting - This setting is intended to assist in thawing of frozen food.
Fan cooking - This allows you to roast or roast and
bake simultaneously using any shelf, without flavour transference.
Grill - The heat comes only from the top element.
Thermostat Control Knob
Turn the thermostat control knob clockwise to select temperatures between 50°C and 250°C (max).
0
FO 2372
Mains on Light
The mains on light will come on when the oven function control knob is set.
Thermostat Control Light
The thermostat control light will come on when the thermostat control knob is turned. The light will remain on until the correct temperature is reached. It will then cycle on and off to show the temperature is being maintained.
50
100
150
FO 2371
200
Before the First Use of the Cooker
INSTALLATION
Any gas installation must be carried out by a CORGI registered installer, and in accordance with existing rules and regulations.
The relevant instructions are to be found in the second section of this manual.
Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown.
WHEN THE COOKER IS FIRST INSTALLED
Once the cooker has been installed, it is important to remove any protective materials, which were put on in the factory.
Remove all packaging, both inside and outside the cooker, before using it.
Before first use, the oven should be heated without food. During this time, an unpleasant odour may be emitted. This is quite normal.
1.Set the time of day with the electronic programmer (see chapter "24 Hour Clock and Timer").
2.Switch the oven function control knob to fan cooking
.
3.Set the thermostat control knob to MAX.
4.Open a window for ventilation.
5.Allow the oven to run empty for approximately 45 minutes.
This procedure should be repeated with the grill function for approximately
6