Installation
Important! First read "Safety information" chapter carefully.
Technical Data
| Dimensions |
Height | 900 mm |
Width | 550 mm |
Depth | 600 mm |
Top oven capacity | 37 l |
Main oven capacity | 74 l |
Location of the appliance
You can install your freestanding appliance with cabinets on one or two sides and in the corner.
B
A
|
| A |
Minimum distances |
| |
|
| |
Dimension |
| mm |
A | 2 | |
B | 685 | |
Levelling
Use small feet on the bottom of appliance to set same lev- el of cooker top surface with other surfaces
18
•Appliance left the factory fully packaged. If it is deliv- ered without packaging and damage has occurred, the manufacturer cannot accept responsibility. Contact your supplier for advice.
•Do not move the appliance by hand after removed the packaging. Do not use a sack barrow or any other aid to lift the appliance. It can cause a damage.
•To move the appliance, open the oven door and lift the appliance by holding inside the top of the component.
•You can fit your freestanding appliance with cabinets on one or both sides and in the corner.
•Protect sidewalls above the hob level by heat resistant noncombustible material and provide minimum 40 mm distance from the sidewalls to the hob side.
•Provide minimum 2 mm air gap at either side of the appliance to enable moving it into position.
•Surfaces above the hob (also cooker hoods) must be a minimum of 685 mm above the hob.
Electrical installation
Warning! Only a qualified and competent person must do the electrical installation.
The manufacturer is not responsible if you do not follow safety precautions from the chapter "Safety
information".
This appliance is supplied without a main plug or a main cable.
Covering terminal board
The recommended
When you refit the mains terminal cover, make sure that the lower tabs are located inside the bottom edge of the aperture, before you fix the two screws into the top edge of the mains terminal cover.
