The furniture door plinth
The door on this appliance is designed for the overlay of a door plinth having the following dimensions:
Width: | 596 mm |
Height: | 50 mm (min) - 120 mm (max) |
Thickness: | 20 mm max |
The panel height should be no more than indicated, otherwise complete opening of the door will no longer be possible as the panel hits against the dishwasher plinth.
Mounting the infill panel
1.Drill the panel with a Ø 2 x 12 bit according to the dimensions indicated in the figure.
2.Fix the panel to the cross bar provided with 2 screws 3.5 x 16.
3.Fix the cross bar to the dishwasher door with 2 screws 3.5 x 16 after having inserted the two hooks of the cross bar on the lower section of the door.
Fixing to the adjacent units
To prevent the dishwasher tilting, it must be secured to either the worktop or adjacent kitchen cabinet/wall using the brackets supplied.
Insert the two fixing brackets into the slots provided in the top front part of the dishwasher as shown in the figure.
Secure the brackets to the adjacent units with the 3.5 x 16 screws using the upper or the side holes.
The appliance must be secured to the underside of the worktop using the brackets provided.
Failure to do this could cause damage or injury.
Attention!
The sides of the dishwasher must never be drilled to prevent damage to hydraulic components.
575 | 820 |
| 50 |
| 120: |
14 | 220 |
| |
II122 |
|
458 |
II69 |
II70 |
II54 |
30 | INS66en |
