CLEANING THE SHELVES, WIREWORK RUNNERS AND GRILL/OVEN FURNITURE
All removable parts, except the grill pan handle, can be washed in the dishwasher.
The meat tin, grill pan, grill pan grid, oven shelves and wirework runners may be cleaned using a soap impregnated steel wool pad. Soaking first in hot soapy water will make cleaning easier.
TO REMOVE THE WIREWORK RUNERS
The wirework runners in the grill and oven cavities can be removed for cleaning.
1.Remove all shelves and furniture from the grill and oven compartments.
2.Hold the wirework at the bottom, unclip from the cavity side and gently pull towards the centre of the grill or oven compartment.
3.Unhook the runner at the top and remove from the cavity.
SIDE PANEL
CAVITY CENTRE
4.To replace, hook the wirework runner back into the grill/oven sides.
Ensure that the wirework runners are firmly in place before refitting the oven shelves.
CLEANING BETWEEN THE OUTER AND INNER DOOR GLASS
To prevent damaging or weakening the door glass panels avoid the use of the following:
Household detergents and bleaches
Impregnated pads unsuitable for non- stick saucepans
Brillo/Ajax pads or steel wool pads
Chemical oven pads or aerosols
Rust removers
Bath/Sink stain removers
Under no circumstances should the door assembly be detached from the product for cleaning. Please refer to the cleaning instructions.
The outer door glass is removable for cleaning.
TO REMOVE THE OUTER GLASS
1.Open the oven door slightly to gain access to the two cross head screws on the top of the oven door.
2.Loosen the two screws using a Pozidrive screwdriver.
Grill Door Trim
3.Hold the door glass securely in place with one hand before removing the screws completely with the other hand.
4.Using both hands, gently tilt the top of the door glass towards you, lift slightly to disengage the locators from the two bottom brackets. The door will remain in a parked position at an angle of approximately 30°C.
5.Clean the outer and inner glass using hot soapy water or Hob Brite may be used with care. DO NOT use Hob Brite on the Stainless Steel or painted finishes. DO NOT try to clean the foil which is inside the door. The foil is there to help keep the door cool, if it is damaged it will not work. Ensure that all parts are well rinsed and thoroughly dried before attempting to replace the outer door.
If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local Service Centre who will be pleased to advise further.
29
