Zanussi ZDF 121 manual Something not working, Fault code / malfunction Possible cause Solution

Something not working

IMPORTANT!

The dishwasher will not start or stops during operation.

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.

Switch off the dishwasher, open the door and carry out the following suggested corrective actions.

Fault code / malfunction	Possible cause	Solution
	The water tap is blocked or furred	Clean the water tap.
The dishwasher does not fill with	with limescale.
water.	The water tap is turned off.	Turn the water tap on.
- continuous flashing of the	The filter (where present) in the .	Clean the filter in the.
	threaded hose fitting at the water	threaded hose fitting.
start/cancel indicator light
	inlet valve is blocked.
- 1 flash of the "end of	The water inlet hose has not been	Check the water inlet hose
programme" indicator light	correctly laid or it is bent or	connection.
	squashed.
The dishwasher will not drain.	The sink spigot is blocked.	Clean out the sink spigot.
- continuous flashing of the	The water drain hose has not been	Check the water drain hose
start/cancel indicator light
- 2 flashes of the "end of	correctly laid or it is bent or	connection.
	squashed.
programme" indicator light
	The dishwasher door has not been	Close the door
	properly closed.
The programme does not start.	The main plug is not plugged in.	Insert the mains plug
	The fuse has blown in the household	Replace the fuse.
	fuse box.

Once these checks have been carried out; close the door, switch on the dishwasher and press the start/cancel button. The programme will continue from the point at which it was interrupted. If the malfunction or fault code reappears contact the Service Force Centre.

For other combinations of fault codes not described in the above chart, please contact your Service Force Centre.

16