Installation instructions
Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it under a close fitting sink unit or a
Proceed as follows:
Remove the machine’s worktop by unscrewing the two rear retaining screws, pull the worktop from the back of the machine and slide out the front slots, lifting the worktop.
Insert the machine after adjusting the levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. During all operations that involve accessibility to internal components the dishwasher has to be unplugged.
Be sure that once the appliance has been installed, it is easily accessible for the service engineer in the event that a repair is required.
If the dishwasher is later used as a
The plinth on
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.
ONLY for model ZDF 601M
Fitting a decor panel on the door
The door of this machine has frames for fitting a laminate decor panel in the colour required to match the dishwasher with the rest of the kitchen furniture.
Note!
The panel should be fitted before positioning the machine.
The panel must have the following dimensions:
Width: | mm 588 |
Height: | mm 586 |
Thickness: | mm 4 max. |
To fit the panel:
- Remove the retaining screws around the edge
- Position the laminate decor panel.
- Tighten the retaining screws around the edge.
20
