156998720en.qxp 1/31/2007 4:22 PM Page 16
Something not working
IMPORTANT!
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.
Switch off the dishwasher, open the door and carry out the following suggested corrective actions.
Fault code / malfunction | Possible cause | Solution | |
| The water tap is blocked or furred | Clean the water tap. | |
The dishwasher does not fill with | with limescale. |
| |
water. | The water tap is turned off. | Turn the water tap on. | |
- continuous flashing of the | The filter (where present) in the . | Clean the filter in the. | |
threaded hose fitting at the water | threaded hose fitting. | ||
start/cancel indicator light | |||
inlet valve is blocked. |
| ||
- 1 flash of the "end of |
| ||
The water inlet hose has not been | Check the water inlet hose | ||
programme" indicator light | correctly laid or it is bent or | connection. | |
| squashed. |
| |
The dishwasher will not drain. | The sink spigot is blocked. | Clean out the sink spigot. | |
- continuous flashing of the | The water drain hose has not been | Check the water drain hose | |
start/cancel indicator light | |||
- 2 flashes of the "end of | correctly laid or it is bent or | connection. | |
squashed. |
| ||
programme" indicator light |
|
| |
- continuous flashing of the | Close the water tap and | ||
start/cancel indicator light |
| contact your local Service | |
- 3 flashes of the "end of |
| Force Centre. | |
programme" indicator light |
|
| |
| The dishwasher door has not been | Close the door | |
The programme does not start. | properly closed. |
| |
The main plug is not plugged in. | Insert the mains plug | ||
| |||
| The fuse has blown in the household | Replace the fuse. | |
| fuse box. |
| |
| Delay start has been selected. | If dishes are to be washed | |
|
| immediately, cancel the delay | |
|
| start. |
Once these checks have been carried out; close the door, switch on the dishwasher and press the start/cancel button. The programme will continue from the point at which it was interrupted. If the malfunction or fault code reappears contact the Service Force Centre.
For other combinations of fault codes not described in the above chart, please contact your Service Force Centre.
16
