8b. Setting and starting the programme with "delay start"

Once a programme and required options

have been selected to useDELAY proceed as follows:

Press the DELAY push button. The digital display will show "h 0". Press the button again to select the number of hours by which you wish to delay the programme start (up to a maximum of 12 hours).

The delay start will not modify the settings made previously .

To set the time setting to zero press the DELAY push button until "h 0" appears in the digital display.

Press the START pushbutton. The digital display shows the delay time required before the start of the programme.

The start of the countdown will be confirmed by the flashing "h" in the digital display.

Once the delayed time has elapsed the

programme will start automatically.

9.To cancel a programme in progress

Press the " START " pushbutton for 5 seconds to cancel the setting or the running

of the current programme.

All the indicator lights will turn off and 3 horizontal lines will appear in the digital display.

After 5 seconds the dishwasher will return to setting mode.

It is now possible to select a new washing programme.

10.At the end of the washing programme

The dishwasher will automatically stop and an intermittent audible signal will sound when the programme has ended.

3 flashing horizontal lines will appear in the digital display and all the indicator lights will turn off.

To return to setting mode press any of the pushbuttons or switch off and then switch on the dishwasher.

Open the door and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved.

Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.

Important!

In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.

Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape.

When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.

17

SEQ07en

Page 17
Image 17
Zanussi ZDS 699 EX manual Current programme, It is now possible to select a new washing programme