Operating sequence

1.Check the filters

Ensure they are clean and properly positioned (see "Maintenance and cleaning").

2.Press the On/Off push button

The display will show the last selected programme and the corresponding phase indicator lights will illuminate.

If the door is open also the "open door" indicator light will illuminate.

3.Check that there is rinse aid

and salt

The corresponding indicator lights will illuminate if refilling is necessary.

4.Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.

Slide the baskets back into the machine.

5.Ensure that the spray arms can rotate freely.

6.Measure out detergent

Add the required amount of detergent into the dispenser.

Close the detergent dispenser lid.

7.Close the dishwasher door

8a. Setting and starting the programme without "delay start"

Press the "programme selector" push button until the required programme number appears in the digital display.

The following options may also be selected:

a-

Half load

by pressing the corresponding

 

push button.

 

 

b-

Eco drying

by pressing the corresponding

 

push button.

 

 

 

Press the

START

push button, an audible

signal advises you that the programme has started.

The display will show the running time

of the programme and the indicator lights of the phases will turn off except for the indicator light of the current phase.

The time in the digital display will start to decrease from minute to minute.

Pressing the "programme selector"

push button while the programme is running will display the number of the current programme.

If the door is opened during the run of the programme the current phase will be interrupted and the digital display will show the number of the programme. The indicator light of the interrupted phase will start to flash and the indicator light "open door" will illuminate.

Once the door is closed the programme will start from the point where it was interrupted.

16

SEQ06en

Page 16
Image 16
Zanussi ZDS 699 EX manual Operating sequence