Zanussi ZDT311 user manual Possible cause and solution, Fault code and malfunction

Fault code and malfunction	Possible cause and solution
• continuous flash of the light of the run-	• The water tap is blocked or furred with limescale.
ning programme	Clean the water tap.
• intermittent audible signal	• The water tap is closed.
• 1 flash of the end indicator light	Open the water tap.
The dishwasher does not fill with water	• The filter in the water inlet hose is blocked.
	Clean the filter.
	• The connection of the water inlet hose is not correct. The hose can
	be kinked or squashed.
	Make sure that the connection is correct.
• continuous flash of the light of the run-	• There is a blockage in the sink spigot.
ning programme	Clean the sink spigot.
• intermittent audible signal	• The connection of the water drain hose is not correct. The hose can
• 2 flashes of the end indicator light	be kinked or squashed.
The dishwasher will not drain	Make sure that the connection is correct.

•continuous flash of the light of the run- • Close the water tap and contact your local Service Force Centre. ning programme

•intermittent audible signal

•3 flashes of the end indicator light

The anti-flood device operates

The programme does not start	• The appliance door is not closed.
	Close the door.
	• Mains plug is not connected in.
	Put in the mains.
	• The fuse has blown out in the household fuse box.
	Replace the fuse.
	• Delay start is set.
	Cancel the delay start to start the programme immediately.

After the check, switch on the appliance. The programme continues from the point of interruption. If the malfunction shows again, contact your Service Force Centre.

These data are necessary to help you quickly and cor- rectly:

•Model (Mod.)

•Product number (PNC)

• Serial number (S.N.)

For these data, refer to the rating plate.

Write the necessary data here:

Model description : ..........

Product number : ..........

Serial number : ..........

14