WARNING!
The electrical cable for the safety valve is in the
Take care when installing the water inlet hose
. Place the water inlet hose in such a way that it is always lower than the bottom edge of the safety valve.
If the water inlet hose or the safety valve is damaged, remove the mains plug immediately.
CAUTION!
A water inlet hose with safety valve MUST only be replaced by your local Service Force Centre.
Drain hose
Connect drain hose to the | Required height: 30 to 100 | Ensure that the hoses are | When connecting the |
sink. | cm above bottom of the | not kinked, crushed or en- | drain hose to an under |
| dishwasher. | tangled. | sink trap spigot, the entire |
|
|
| plastic membrane (A) |
|
|
| must be removed. Fail- |
|
|
| ure to remove all the mem- |
|
|
| brane will result in food |
|
|
| particles building up over |
|
|
| time eventually blocking |
|
|
| the dishwasher drain hose |
|
|
| spigot. |
If you use a drain hose extension the total length should not be longer than 4 metres. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.
23
