Door reversal directions
1.Disconnect from the electricity supply.
2.Gently lay the fridge on its back with the top held away from the floor by
3.Remove the ventilation grill (D).
4.remove the bottom hinge (E) by unscrewing its three fixing screws;
5.Slide out the fridge door from pin (G), unscrew the latter and then refit it on the opposite side;
6.remove the two plugs of the door (where available), discovering the holes for the hinge pins, assemble them on the opposite side;
7.reassemble the door;
8.using a 10 mm spanner, unscrew the hinge pin
(E) and reassemble it on the opposite side of the hinge;
9.reassemble the lower hinge (E) on the opposite side, using the screws previously removed. Slide the hole cover (F) out of the ventilation grille (D) by pushing it in the direction of the arrow and reassemble it on the opposite side;
10.refit the ventilation grille (D), clipping it into place;
11.Unscrew the handle. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs supplied in the documentation pack.
Important
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
| E | E |
F |
| |
| F | |
|
| |
|
| F |
|
| D |
| F |
|
G |
14
Printed on recycled paper
