American Standard 2555.400  Finish Drain Installation,  Install Handles, Figure A, Figure C

FINISH DRAIN INSTALLATION

Position BIDET fixture and secure to floor.

Insert lift rod into lift rod guide.

Position EXTENSION ROD (1) onto POP-UP ROD (2) and tighten THUMBSCREW (3).

Remove one end of CLIP (4) from PIVOT ROD (7) by squeezing ends together while sliding.

Insert PIVOT ROD (7) into second or third hole in EXTENSION ROD (1) and reassemble CLIP (4). (EXTENSION ROD (1) may need to be bent.)

Adjust STOPPER height by repositioning EXTENSION ROD (1) on POP-UP ROD (2) and tightening THUMBSCREW (3).

Using metal TAILPIECE (5), make connection to the TRAP (6).

2

1

3

17

5

4

6

INSTALL HANDLES

Turn VALVE to OFF position.

Figure A: Install STEM ADAPTERS (7) onto VALVE STEMS (8).

Figure B: With colored side up, place FRICTION RING (6) over DECK ADAPTER (10). Loosely screw FRICTION NUT (5) onto DECK ADAPTER (10). Do not tighten. Align flats on FRICTION

NUT (5) with RIBS (9) in HANDLE BASE (4).

Figure C: Screw HANDLE BASE (4) with FRICTION NUT (5) onto DECK ADAPTER (10) until snug against mounting surface and aligned properly.

Figure D: Install LEVER HANDLE (3) onto HANDLE ADAPTER (7) and align. Check alignment, if not satisfactory remove and align. Insert HANDLE SCREW (2) and tighten. Press in

INDEX BUTTON (1).

B INSTALL DIVERTER KNOB

Diverter Knob; Push DIVERTER KNOB (11) onto HANDLE ADAPTER (12). Push on RING (13) and tighten with SCREW (14). Press on KNOB CAP (15). (The screwdriver Gap for disassembling should face downwards).

15

14 13

11

12

	5
	6	4	9
	7
	8			4
		5
Figure A	10			5
		FLATS
	1			10
2
	3		6
	4			ALIGNED
			10	Figure C
Figure D		Figure B

.      
3 & 7