SPRAY INSTALLATION
Assemble SPRAY BODY (1) to BIDET.
Using putty, seal underside of SPRAY
BODY FLANGE (2) and secure with
NUT (3).
Thread SPRAY HOSE (4) with SEAL WASHER (5) to SPRAY BODY (1). Connect other end of HOSE (4) with SEAL WASHER (6) to bottom outlet NIPPLE (7) of the TRANSFER VALVE (8).
Thread SPRAY CAP (9) onto SPRAY BODY (1).
8 | 2 | 9 |
PUTTY |
| |
7 | 1 | |
6 |
| |
|
|
3
5
4
LIFT ROD GUIDE INSTALLATION
Unscrew LIFT ROD NUT (1) from LIFT ROD GUIDE (2).
Make sure SEAL (3) is seated into ESCUTCHEON of LIFT ROD GUIDE (2).
Drop LIFT ROD GUIDE (2) into rear hole of bidet and from below secure with ROD GUIDE NUT (1).
2
3
1
TEE AND HOSE CONNECTION
Insert SEAL (1) into ADAPTER (2) and tighten ADAPTER (2) to side of TRANSFER VALVE (3)
Install SEAL (4) into coupling nut of TEE (5) and |
|
| 6 |
tighten connection to ADAPTER (2) |
|
| |
|
|
| |
Connect HOSE COUPLING NUTS (6) to Hot | 6 |
|
|
and Cold valve bodies and securely tighten. |
|
|
|
| 5 | 4 | 3 |
|
| ||
|
| 2 | 1 |
| Front |
| |
WATER SUPPLY CONNECTIONS
NOTE: FLEXIBLE SUPPLIES ARE NOT INCLUDED AND HAVE TO BE PURCHASED SEPARATELY.
Connect water supplies to FITTING (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D.
Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.
1
2 | COUPLING NUT |
| 3 |
Hot | Cold |
| FERRULE |
. 3 & 7
