INSTALLATION
Installing Logs (EFP33PR/EFP33NR)
23
INSTALLATION
Continued
INSTALLING LOGS (EFP33PR/EFP33NR)
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: Do not remove the warning and in- struction labels attached to the heater base assem- bly. These markings contain important warranty information.
CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HIGH, check to see if flames contact any log. If so, reposition logs ac- cording to the log installation instructions in this manual. Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place the base of the middle log (#1) in the
2.Locate pegs on the bottom of back log (#2). Slide these pegs into the holes in the grate base behind the burner (see Figure 50).
3.Locate the notches in the bottom of the front log (#3). Place the front log on the grate fingers. Make sure the notches of the front log line up with the grate fingers (see Figure 51).
4.Place crossover log (#4) onto the peg (right) on back log (#2) and into the recess of the middle log (#1) (see Figure 52).
Middle | Back Log (#2) |
Log (#1) |
|
"U"- | Peg |
shaped | |
Cutout |
|
in Base |
|
Peg
Burner |
|
Figure 49 - Installing Middle | Figure 50 - Installing Back |
Log (#1) | Log (#2) |
Front
Log (#3)
Crossover
Log (#4)
Notches
Peg
Grate |
|
Fingers | Recess |
|
Figure 51 - Installing Front | Figure 52 - Installing |
Log (#3) | Crossover Log (#4) |
For more
visit www.
.com
108117
