INSTALLING LOGS CGEFP33PR/CGEFP33NR, Installation, Continued

INSTALLATION

Installing Logs (VTGF33NR/VTGF33PR) (Cont.) Installing Logs (CGEFP33PR/CGEFP33NR)

INSTALLATION

Continued

	Peg	Rear
	Peg	Log (#3)
		Log (#3)
Groove		Groove	Crossover
		in Back	Crossover
		in Back	Log (#4)
in Back		of Log	Log (#4)
in Back		of Log
of Log		Cutout	Hole
Grate			Peg
Prong

	Grate
	Prong
Figure 43 - Installing	Figure 44 - Installing
Rear Log (#3)	Crossover Log (#4)

INSTALLING LOGS (CGEFP33PR/CGEFP33NR)

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: Do not remove the warning and in- struction labels attached to the heater base assem- bly. These markings contain important warranty in- formation.

CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HIGH, check to see if flames contact any log. If so, reposition logs ac- cording to the log installation instructions in this manual. Flames contacting logs will create soot.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in the grate base behind the burner (see Figure 45).

2.Place the base of the middle log (#2) in the U-shaped slots of the grate base in front of the back log. The cutout on the right of the middle log should fit over the burner (see Figure 46). Make sure the front of the middle log is resting on the tabs of the grate base and the cutout area is centered over the burner “U” bend.

3.Locate the recesses on the back of the front log (#3). Fit these recesses between the posts of the grate base (see Figure 47).

4.Locate the notches in the bottom of the crossover log (#4). Place the crossover log on top of the middle log and front log. Make sure the notches of the crossover log lines up with rectangular knobs on top of the middle and front logs (see Figure 48).