Sapphire Audio Logset Installation, DV425TR DIRECT VENT ROOM HEATER, Fig. Fig. Fig. Fig

DV425TR DIRECT VENT ROOM HEATER

LOGSET INSTALLATION

The logset is packed in the components box and consists of the

following: (See Fig. 1)
Qty.		# in Fig. 1
1	Rear log -	1
1	Left Partial Log -	2
1	Right Partial Log -	3
1	Left Twig -	4
1	Right Twig -	5

While breakable, the logs do not become fragile until after the stove is burned and they have cured. After curing, any handling must be done with care as breakage may occur easily.

Please Note: Logs have been designed to work specifically with the burner pan of the 425TR. Exact placement will ensure maximum operation of your heater.

Installation:

1.Set the Rear Log over the pins at the rear of burner pan. (See white circles in Fig. 2)

2.Set Left and Right Partial Logs (with butt end towards side of stove firebox), over the left and right side pins on burner pan. Fig. 3

3.Locate the pin hole on the bottom of the right and left twigs and situate them over the white pins located on Rear Log.

Fig. 4

IMPORTANT!

Lava rock must only be placed in the recessed area to the front and sides of burner pan.

4.Place nuggets sparingly across front of burner. Note the white nuggets in Fig. 5

5.Tear off varying sizes of mineral wool and intersperse among the nuggets.

6.Carefully deposit a layer of lava rock in the channel area along both sides and in front. Fig. 6

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 1

		1
4		5
	2	3

Fig. 6

Channel area to keep lava rock in is shaped like this outline.

02/01 Page 15 250-5533